umu.sePublikasjoner
Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Slagging and fouling characteristics during co-combustion of Scots pine bark with low-temperature dried pulp and paper mill chemical sludge
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Institutionen för fysik.
Vise andre og tillknytning
2019 (engelsk)Inngår i: Fuel processing technology, ISSN 0378-3820, E-ISSN 1873-7188, Vol. 193, s. 282-294Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

This paper shows how chemical sludge (CS) generated during wastewater treatment at a paperboard mill can be quickly dried at low-temperature and employed in bark-fired boilers to reduce slagging and corrosion problems. By using a cyclone-dryer operated at an inlet-air velocity of 110 m/s and a temperature of 90 degrees C, the dry-matter content of CS was increased from approximately 19 to 82%. The residence time of CS inside the cyclone was approximately 2 s when using the inlet-air velocity mentioned above. Disaggregation of the feedstock caused by collisions with the cyclone wall and between particles played a crucial role in enhancing the efficiency of heat and mass transfer. Three co-pelletized mixtures of Scots pine bark (SPB) and dried-CS were combusted in a 40 kW fixed-bed burner. Flue gas analysis was performed with a gas analyser. Coarse and fine ash were analysed by SEM-EDS and XRD. NO,, and SO2 emissions increased with increasing amount of CS in the mixtures. Mono combustion of SPB resulted in a large quantity of slag (i.e., molten ash) with a high degree of sintering (i.e., hardness of the slag), and ash deposits formed on heat transfer surfaces were rich in K2SO4 and KCI. Mixtures of SPB and CS were less prone to slagging, and the amount of alkali chloride in the deposits was reduced in favour of alkali sulphate formation.

sted, utgiver, år, opplag, sider
Elsevier, 2019. Vol. 193, s. 282-294
Emneord [en]
Pulp and paper mill sludge, Drying, Combustion, NOx, SO2, Slag, Fouling
HSV kategori
Forskningsprogram
fysik
Identifikatorer
URN: urn:nbn:se:umu:diva-161685DOI: 10.1016/j.fuproc.2019.05.019ISI: 000473842100029Scopus ID: 2-s2.0-85066129785OAI: oai:DiVA.org:umu-161685DiVA, id: diva2:1340641
Prosjekter
Bio4Energy
Forskningsfinansiär
Swedish Research Council Formas, 213-2014-182Bio4EnergyTilgjengelig fra: 2019-08-06 Laget: 2019-08-06 Sist oppdatert: 2019-11-04bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Personposter BETA

Salh, Roushdey

Søk i DiVA

Av forfatter/redaktør
Salh, Roushdey
Av organisasjonen
I samme tidsskrift
Fuel processing technology

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 26 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf