umu.sePublikationer
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Activation of dissolving celluloses pulp for viscose and cellulose ether production
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen.
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen.
AkzoNobel.
AkzoNobel.
Visa övriga samt affilieringar
2016 (Engelska)Ingår i: The 7th workshop on cellulose, regenerated cellulose and cellulose derivatives / [ed] Ola Sundman, Umeå ; Karlstad: Umeå university ; Karlstad university , 2016, s. 29-30Konferensbidrag, Muntlig presentation med publicerat abstract (Övrigt vetenskapligt)
Abstract [en]

Mercerisation of cellulose by alkali treatment is the most common procedure used to activate natural cellulose fibres into many commercial cellulosic materials. During mercerisation, the NaOH solution enters the cellulose fibres, transforming them into a swollen and a highly reactive material called alkali cellulose (Na-Cell). In case NaOH is completely washed out of the cellulose structure, Na-Cell turns into Cellulose II upon drying.

Traditionally the cellulose is mercerised by suspending it in a 15-20 % NaOH solution. The result is a high (15-25 mol/mol) NaOH: Anhydroglucose  molar ratio (r) and mercerisation in these conditions have been extensively studied. However, in modern production of cellulose ethers, the mercerisation conditions are often very different. The main reason is that any excess of water and OH--ions used during the mercerisation can later react with different chemicals in the process, thus forming unwanted by-products e.g. methanol. One way to avoid this kind of side reaction is by using low-water-content mercerisation conditions, i.e. low (r) = 0.8-1.8 mol/mol and high NaOH concentration (45-55% w/w). The traditional mercerisation is a suspension process while the cellulose during the latter process, i.e low-water-content mercerisation conditions, remains quite “dry”. Thus, although the chemical reaction principles of activation of cellulose for both viscose and cellulose ethers processes are the same, the activation conditions used are often very different. Therefore, the different dependencies of process parameters as well as any similarities between the processes are interesting.

The presentation summarises the findings presented in two papers which described the influence of the different parameters on the mercerisation/activation of softwood Sulphite dissolving pulp in viscose production conditions (Albán Reyes et al. 2016) and cellulose derivatives production conditions (Albán Reyes et al.) respectively. In the individual studies this has been done by analysing the degree of transformation (DoT) of dissolving pulp to Na-cellulose (or more correctly cellulose II after washing and upon drying) as a function of simultaneous variation of [NaOH], temperature, and reaction time varied using design of experiment. Also the (r) was varied for samples mercerised at dry conditions. A combination of Raman imaging and multivariate data analysis have been used to study the DoT to Cellulose II.

It was found that the mercerisation under the different conditions was dependent on different parameters. For traditional mercerisation, on the one hand, the temperature was shown to be important for the DoT and showed negative correlation with the data, while [NaOH] showed a positive correlation. On the other hand, at low-water-content mercerisation conditions the (r) was overall most important while the temperature showed no statistical importance in a Partial least squares analysis. Traditional mercerisation gave much higher DoT than the low-water-content mercerisation. Thus,  the data for low-water-content mercerisation was further examined at the different (r). The same chemistry is always expected and the different influences of the parameters seen is understood and discussed in terms of the different physical reaction mechanisms.  

Ort, förlag, år, upplaga, sidor
Umeå ; Karlstad: Umeå university ; Karlstad university , 2016. s. 29-30
Nyckelord [en]
cellulose, swelling, NaOH, cellulose ether production
Nationell ämneskategori
Annan kemi
Identifikatorer
URN: urn:nbn:se:umu:diva-128501OAI: oai:DiVA.org:umu-128501DiVA, id: diva2:1052104
Konferens
The 7th workshop on cellulose, regenerated cellulose and cellulose derivatives, Örnsköldsvik, November 15-16, 2016
Tillgänglig från: 2016-12-05 Skapad: 2016-12-05 Senast uppdaterad: 2019-01-08Bibliografiskt granskad

Open Access i DiVA

fulltext(101 kB)15 nedladdningar
Filinformation
Filnamn FULLTEXT01.pdfFilstorlek 101 kBChecksumma SHA-512
3601e81df40e37800df5837a07a523fcd7133bf69d643e7055372e692a185326d5a154ea46bc3d728a3442822e9286eb8290475cee6140f507dc67bf98e1141e
Typ fulltextMimetyp application/pdf

Personposter BETA

Albán Reyes, Diana CarolinaEliasson, BertilSundman, Ola

Sök vidare i DiVA

Av författaren/redaktören
Albán Reyes, Diana CarolinaEliasson, BertilSundman, Ola
Av organisationen
Kemiska institutionen
Annan kemi

Sök vidare utanför DiVA

GoogleGoogle Scholar
Totalt: 15 nedladdningar
Antalet nedladdningar är summan av nedladdningar för alla fulltexter. Det kan inkludera t.ex tidigare versioner som nu inte längre är tillgängliga.

urn-nbn

Altmetricpoäng

urn-nbn
Totalt: 1776 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf