Change search
ReferencesLink to record
Permanent link

Direct link
Simple Dip-Coating Process for the Synthesis of Small Diameter Single-Walled Carbon Nanotubes-Effect of Catalyst Composition and Catalyst Particle Size on Chirality and Diameter
Umeå University, Faculty of Science and Technology, Department of Physics.
Umeå University, Faculty of Science and Technology, Department of Physics.
Umeå University, Faculty of Science and Technology, Department of Physics.
Umeå University, Faculty of Science and Technology, Department of Chemistry.
Show others and affiliations
2012 (English)In: The Journal of Physical Chemistry C, ISSN 1932-7447, E-ISSN 1932-7455, Vol. 116, no 22, 12232-12239 p.Article in journal (Refereed) Published
Abstract [en]

We report on a dip-coating method to prepare catalyst particles (mixture of iron and cobalt) with a controlled diameter distribution on silicon wafer substrates by changing the solution's concentration and withdrawal velocity. The size and distribution of the prepared catalyst particles were analyzed by atomic force microscopy. Carbon nanotubes were grown by chemical vapor deposition on the substrates with the prepared catalyst particles. By decreasing the catalyst particle size to below 10 nm, the growth of carbon nanotubes can be tuned from few-walled carbon nanotubes, with homogeneous diameter, to highly pure single-walled carbon nanotubes. Analysis of the Raman radial breathing modes, using three different Raman excitation wavelengths (488, 633, and 785 nm), showed a relatively broad diameter distribution (0.8-1.4 nm) of single-walled carbon nanotubes with different chiralities. However, by changing the composition of the catalyst particles while maintaining the growth parameters, the chiralities of single-walled carbon nanotubes were reduced to mainly four different types, (12, 1), (12, 0), (8, 5), and (7, 5), accounting for about 70% of all nanotubes.

Place, publisher, year, edition, pages
2012. Vol. 116, no 22, 12232-12239 p.
National Category
Nano Technology
URN: urn:nbn:se:umu:diva-56974DOI: 10.1021/jp211064cISI: 000304888700046OAI: diva2:539332
Available from: 2012-07-03 Created: 2012-07-02 Last updated: 2015-01-04Bibliographically approved
In thesis
1. Synthesis and Characterization of Carbon Based One-Dimensional Structures: Tuning Physical and Chemical Properties
Open this publication in new window or tab >>Synthesis and Characterization of Carbon Based One-Dimensional Structures: Tuning Physical and Chemical Properties
2015 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Carbon nanostructures have been extensively used in different applications; ranging from electronic and optoelectronic devices to energy conversion. The interest stems from the fact that covalently bonded carbon atoms can form a wide variety of structures with zero-, one- and two-dimensional configuration with different physical properties. For instance, while fullerene molecules (zero-dimensional carbon structures) realize semiconductor behavior, two-dimensional graphene shows metallic behavior with exceptional electron mobility. Moreover the possibility to even further tune these fascinating properties by means of doping, chemical modification and combining carbon based sub-classes into new hybrid structures make the carbon nanostructure even more interesting for practical application. 

This thesis focuses on synthesizing SWCNT and different C60 one-dimensional structures as well as tuning their properties by means of different chemical and structural modification. The purpose of the study is to have better understanding of the synthesis and modification techniques, which opens for better control over the properties of the product for desired applications.

In this thesis carbon nanotubes (CNTs) are grown by chemical vapor deposition (CVD) on iron/cobalt catalyst particles. The effect of catalyst particle size on the diameter of the grown CNTs is systematically studied and in the case of SWCNTs it is shown that the chirality distribution of the grown SWCNTs can be tuned by altering the catalyst particle composition. In further experiments, incorporation of the nitrogen atoms in SWCNTs structures is examined. A correlation between experimental characterization techniques and theoretical calculation enable for precise analysis of different types of nitrogen configuration in SWCNTs structure and in particular their effect on growth termination and electronic properties of SWCNTs are studied.

C60 one-dimensional structures are grown through a solution based method known as Liquid-liquid interfacial precipitation (LLIP). By controlling the crystal seed formation at the early stage of the growth the morphology and size of the grown C60 one-dimensional structures where tuned from nanorods to large diameter rods and tubes. We further introduce a facile solution-based method to photo-polymerize the as-grown C60 nanorods, and show that such a method crates a polymeric C60 shell around the nanorods. The polymeric C60 shell exhibits high stability against common hydrophobic C60 solvents, which makes the photo-polymerized nanorods ideal for further solution-based processing. This is practically shown by decoration of both as grown and photo-polymerized nanorods by palladium nanoparticles and comparison between their electrochemical activities. The electrical properties of the C60 nanorods are also examined by utilizing a field effect transistor geometry comprising different C60 nanorods.

In the last part of the study a variant of CNT is synthesized in which large diameter, few-walled CNTs spontaneously transform to a collapsed ribbon shape structure, the so called collapsed carbon nanotube (CCNT). By inserting C60 molecules into the duct edges of CCNT a new hybrid structure comprising C60 molecules and CCNT is synthesized and characterized. A further C60 insertion lead to reinflation of CCNTs, which eventually form few-walled CNT completely filled with C60 molecules.

Place, publisher, year, edition, pages
Umeå: Umeå University, 2015. 71 p.
Carbon Nanotube, single-walled carbon nanotube, nitrogen doped, chemical vapor deposition, fullerene, hybrid structures
National Category
Condensed Matter Physics
Research subject
urn:nbn:se:umu:diva-97551 (URN)978-91-7601-191-1 (ISBN)
Public defence
2015-01-28, MA121, MIT Huset, Umeå, 13:00 (English)
Available from: 2015-01-07 Created: 2014-12-22 Last updated: 2015-01-04Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Barzegar, Hamid R.Nitze, FlorianSharifi, TivaRamstedt, MadeleineWågberg, Thomas
By organisation
Department of PhysicsDepartment of Chemistry
In the same journal
The Journal of Physical Chemistry C
Nano Technology

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 190 hits
ReferencesLink to record
Permanent link

Direct link