Change search
ReferencesLink to record
Permanent link

Direct link
Production Code Generation for Rapid Prototyping of Control System using TargetLink
Umeå University, Faculty of Science and Technology, Department of Applied Physics and Electronics.
2012 (English)Independent thesis Advanced level (degree of Master (Two Years)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

The objectives of this research is to describe how to generate a production codeautomatically by using TargetLink from Matlab/Simulink for implementing RapidControl Prototyping algorithms on a standard supported microprocessor board and toevaluate the eciency and possible limitations for implementing the generatedproduction code over standard Microprocessor platform MPC5554EVB.

Place, publisher, year, edition, pages
, EL1207
National Category
Control Engineering
URN: urn:nbn:se:umu:diva-58368Local ID: EL1207OAI: diva2:548373
Educational program
Master's Programme in Robotics and Control
Available from: 2012-09-12 Created: 2012-08-29 Last updated: 2012-09-12Bibliographically approved

Open Access in DiVA

No full text

By organisation
Department of Applied Physics and Electronics
Control Engineering

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 395 hits
ReferencesLink to record
Permanent link

Direct link