umu.sePublikationer
Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Modular pressurized liquid extraction for simultaneous extraction, clean-up and fractionation of PCDD/Fs in soil, sediment and sludge samples
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen.
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen.
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen.
Umeå universitet, Teknisk-naturvetenskapliga fakulteten, Kemiska institutionen. (EcoChange)ORCID-id: 0000-0003-2293-7913
2013 (Engelska)Ingår i: Analytical Methods, ISSN 1759-9660, E-ISSN 1759-9679, nr 5, s. 1231-1237Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

Modular pressurized liquid extraction (M-PLE) procedures were developed for simultaneous extraction, clean-up and fractionation of polychlorinated dioxins and furans (PCDD/Fs) in soil, sediment and sludge samples. The procedures utilize two coupled extraction cells: an upstream cell filled with the sample and layers of silica and acid- and base-modified silica, and a downstream cell filled with activated carbon. The silica layers were added to remove polar or hydrolysable matrix components, and the carbon to perform planarity-based fractionation. Two solvent systems (dichloromethane–heptane, DCM–Hp and diethyl ether–heptane, DEE–Hp) and two activated carbon loads (1% and 3% carbon on Celite) were evaluated using certified reference materials (CRM-529 and WMS-01) and materials from previous inter-calibration studies. Using any of the four procedures, data statistically equivalent to the certified or reference values were obtained. The M-PLE procedure using DCM–Hp and 1% carbon sometimes extracted the reference materials more efficiently than the reference methods, while the DEE–Hp procedure extracted them equally efficient, offering an alternative with less environmental impact. The methods with 1% carbon on Celite produced sufficiently pure extracts for sample loads up to one gram, but for greater sample loads the higher carbon load (3% carbon on Celite) was required to avoid breakthrough of target analytes. The new streamlined procedures are fast, cost-efficient, involve relatively low environmental impact (in the case of DEE–Hp) and are well suited for high-throughput analysis of solid samples, e.g. in connection with environmental monitoring campaigns and major soil remediation efforts.

Ort, förlag, år, upplaga, sidor
RSC Publishing, 2013. nr 5, s. 1231-1237
Nationell ämneskategori
Analytisk kemi
Identifikatorer
URN: urn:nbn:se:umu:diva-66705DOI: 10.1039/C2AY26411KISI: 000314892900018OAI: oai:DiVA.org:umu-66705DiVA, id: diva2:608604
Tillgänglig från: 2013-02-28 Skapad: 2013-02-28 Senast uppdaterad: 2019-04-09Bibliografiskt granskad
Ingår i avhandling
1. New tools for sample preparation and instrumental analysis of dioxins in environmental samples
Öppna denna publikation i ny flik eller fönster >>New tools for sample preparation and instrumental analysis of dioxins in environmental samples
2013 (Engelska)Doktorsavhandling, sammanläggning (Övrigt vetenskapligt)
Abstract [en]

Polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs), two groups of structurally related chlorinated aromatic hydrocarbons, are of high concern due to their global distribution and extreme toxicity. Since they occur at very low levels, their analysis is complex, challenging and hence there is a need for efficient, reliable and rapid alternative analytical methods. Developing such methods was the aim of the project this thesis is based upon.

During the first years of the project the focus was on the first parts of the analytical chain (extraction and clean-up). A selective pressurized liquid extraction (SPLE) procedure was developed, involving in-cell clean-up to remove bulk co-extracted matrix components from sample extracts. It was further streamlined by employing a modular pressurized liquid extraction (M-PLE) system, which simultaneously extracts, cleans up and isolates planar PCDD/Fs in a single step. Both methods were validated using a wide range of soil, sediment and sludge reference materials. Using dichloromethane/n-heptane (DCM/Hp; 1/1, v/v) as a solvent, results statistically equivalent to or higher than the reference values were obtained, while an alternative, less harmful non-chlorinated solvent mixture - diethyl ether/n-heptane (DEE/Hp; 1/2, v/v) – yielded data equivalent to those values.

Later, the focus of the work shifted to the final instrumental analysis. Six gas chromatography (GC) phases were evaluated with respect to their chromatographic separation of not just the 17 most toxic congeners (2,3,7,8-substituted PCDD/Fs), but all 136 tetra- to octaCDD/Fs. Three novel ionic liquid columns performed much better than previously tested commercially available columns. Supelco SLB-IL61 offered the best overall performance, successfully resolving 106 out of the 136 compounds, and 16 out of the 17 2,3,7,8-substituted PCDD/Fs. Another ionic liquid (SLB-IL111) column provided complementary separation. Together, the two columns separated 128 congeners. The work also included characterization of 22 GC columns’ selectivity and solute-stationary phase interactions. The selectivities were mapped using Principal Component Analysis (PCA) of all 136 PCDD/F’s retention times on the columns, while the interactions were probed by analyzing both the retention times and the substances’ physicochemical properties.

Ort, förlag, år, upplaga, sidor
Umeå: Umeå universitet, 2013. s. 39
Nyckelord
PCDD/Fs, dioxins, pressurized liquid extraction, PLE, selective SPLE, modular M-PLE, soil, sediment, sludge, gas chromatography, new stationary phases, multivariate data analysis, selectivity, interaction
Nationell ämneskategori
Miljövetenskap Analytisk kemi
Forskningsämne
biologi, miljövetenskap
Identifikatorer
urn:nbn:se:umu:diva-70218 (URN)978-91-7459-683-0 (ISBN)
Disputation
2013-06-05, KBC-huset, KB3A9, Umeå Universitet, Umeå, 09:00 (Engelska)
Opponent
Handledare
Tillgänglig från: 2013-05-15 Skapad: 2013-05-08 Senast uppdaterad: 2019-04-09Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltext

Personposter BETA

Do, LanLundstedt, StaffanHaglund, Peter

Sök vidare i DiVA

Av författaren/redaktören
Do, LanLundstedt, StaffanHaglund, Peter
Av organisationen
Kemiska institutionen
I samma tidskrift
Analytical Methods
Analytisk kemi

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 300 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf