Change search
ReferencesLink to record
Permanent link

Direct link
Time Dependence of Bed Particle Layer Formation in Fluidized Quartz Bed Combustion of Wood-Derived Fuels
Umeå University, Faculty of Science and Technology, Department of Applied Physics and Electronics.
2014 (English)In: Energy & Fuels, ISSN 0887-0624, E-ISSN 1520-5029, Vol. 28, no 6, 3841-3848 p.Article in journal (Refereed) Published
Abstract [en]

Formation of sticky layers on bed particles has been considered as a prerequisite for bed agglomeration in fluidized bed combustion of wood-derived fuels. The present investigation was undertaken to determine the quartz bed particle layer formation process in fluidized bed combustion of wood-derived fuels. Bed material samples from three different appliances, bench-scale bubbling fluidized bed, full-scale bubbling fluidized bed, and full-scale circulating fluidized bed, at different sampling times from startup with a fresh bed were collected. Scanning electron microscopy/energy-dispersive spectroscopy (SEM/EDS) and X-ray diffraction (XRD) were used to explore layer morphology and chemical composition and to gain information on crystalline phases of the layers and coatings. Significant differences in layer morphology and composition were found for quartz bed particles with different ages. For bed samples with operational duration of less than 1 day, only one thin Ca-, Si-, O-, and K-rich homogeneous quartz bed particle layer that has a relatively high K/Ca molar ratio was found. For quartz bed particles with an age from around 1 day to 2 weeks, an outer more particle-rich coating layer was also found. During the initial days of this period, the layer growth rate was high but decreased over time, and decreasing K/Ca and increasing Ca/Si molar ratios in the inner bed particle layer were observed. For bed particles with age between 2 and 3 weeks, a much lower layer growth rate was observed. At the same time, the Ca/Si molar ratio reached high values and the K concentration remained on a very low level. In addition to these layer formation processes mentioned, also an inner-inner/crack layer was also formed in the circulating fluidized bed quartz bed particles simultaneously with the inner bed particle layer.

Place, publisher, year, edition, pages
2014. Vol. 28, no 6, 3841-3848 p.
National Category
Chemical Sciences
URN: urn:nbn:se:umu:diva-91279DOI: 10.1021/ef500386kISI: 000337783800032OAI: diva2:735464
Available from: 2014-07-28 Created: 2014-07-28 Last updated: 2014-07-28Bibliographically approved

Open Access in DiVA

fulltext(8164 kB)125 downloads
File information
File name FULLTEXT01.pdfFile size 8164 kBChecksum SHA-512
Type fulltextMimetype application/pdf

Other links

Publisher's full text

Search in DiVA

By author/editor
Boström, Dan
By organisation
Department of Applied Physics and Electronics
In the same journal
Energy & Fuels
Chemical Sciences

Search outside of DiVA

GoogleGoogle Scholar
Total: 125 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Altmetric score

Total: 56 hits
ReferencesLink to record
Permanent link

Direct link