Umeå University's logo

The role of lignin in enzymatic saccharification of cellulose involving lytic polysaccharide monooxygenase (LPMO) was investigated in experiments with the solid and liquid fractions of pretreated Norway spruce from a biorefinery demonstration plant using hydrothermal pretreatment and impregnation with sulfur dioxide. Pretreated biomass before and after enzymatic saccharification was characterized using HPAEC, HPLC, Py-GC/MS, 2D-HSQC NMR, FTIR, and SEM. Chemical characterization indicated that relatively harsh pretreatment conditions resulted in that the solid phase contained no or very little hemicellulose but considerable amounts of pseudo-lignin, and that the liquid phase contained a relatively high concentration (∼5 g/L) of lignin-derived phenolics. As judged from reactions continuously supplied with either air or nitrogen gas, lignin and lignin fragments from both the solid and the liquid phases efficiently served as reductants in LPMO-supported saccharification. When air was used to promote LPMO activity, the enzymatic conversion of cellulose after 72 h was 25% higher in reactions with pretreated solids and buffer, and 14% higher in reactions with pretreatment liquid and microcrystalline cellulose. Research in this area is useful for designing efficient saccharification steps in biochemical conversion of lignocellulosic biomass.

Background: High substrate concentrations and high sugar yields are important aspects of enzymatic saccharification of lignocellulosic substrates. The benefit of supporting the catalytic action of lytic polysaccharide monooxygenase (LPMO) through continuous aeration of slurries of pretreated softwood was weighed against problems associated with increasing substrate content (quantitated as WIS, water-insoluble solids, in the range 12.5–17.5%), and was compared to the beneficial effect on the saccharification reaction achieved by increasing the enzyme preparation (Cellic CTec3) loadings. Aerated reactions were compared to reactions supplied with N2 to assess the contribution of LPMO to the saccharification reactions. Analysis using 13C NMR spectroscopy, XRD, Simons’ staining, BET analysis, and SEM analysis was used to gain further insights into the effects of the cellulolytic enzymes on the substrate under different reaction conditions.

Results: Although glucose production after 72 h was higher at 17.5% WIS than at 12.5% WIS, glucan conversion decreased with 24% (air) and 17% (N2). Compared to reactions with N2, the average increases in glucose production for aerated reactions were 91% (12.5% WIS), 70% (15.0% WIS), and 67% (17.5% WIS). Improvements in glucan conversion through aeration were larger (55–86%) than the negative effects of increasing WIS content. For reactions with 12.5% WIS, increased enzyme dosage with 50% improved glucan conversion with 25–30% for air and N2, whereas improvements with double enzyme dosage were 30% (N2) and 39% (air). Structural analyses of the solid fractions revealed that the enzymatic reaction, particularly with aeration, created increased surface area (BET analysis), increased disorder (SEM analysis), decreased crystallinity (XRD), and increased dye adsorption based on the cellulose content (Simons' staining).

Conclusions: The gains in glucan conversion with aeration were larger than the decreases observed due to increased substrate content, resulting in higher glucan conversion when using aeration at the highest WIS value than when using N2 at the lowest WIS value. The increase in glucan conversion with double enzyme preparation dosage was smaller than the increase achieved with aeration. The results demonstrate the potential in using proper aeration to exploit the inherent capacity of LPMO in enzymatic saccharification of lignocellulosic substrates and provide detailed information about the characteristics of the substrate after interaction with cellulolytic enzymes.

Enzymatic saccharification is used to convert polysaccharides in lignocellulosic biomass to sugars which are then converted to ethanol or other bio-based fermentation products. The efficacy of commercial cellulase preparations can potentially increase if lytic polysaccharide monooxygenase (LPMO) is included. However, as LPMO requires both a reductant and an oxidant, such as molecular oxygen, a reevaluation of process configurations and conditions is warranted. Saccharification and fermentation of pretreated softwood was investigated in demonstration-scale experiments with 10 m³ bioreactors using an LPMO-containing cellulase preparation, a xylose-utilizing yeast, and either simultaneous saccharification and fermentation (SSF) or hybrid hydrolysis and fermentation (HHF) with a 24-hour or 48-hour initial phase and with 0.15 vvm aeration before addition of the yeast. The conditions used for HHF, especially with 48 h initial phase, resulted in better glucan conversion, but in poorer ethanol productivity and in poorer initial ethanol yield on consumed sugars than the SSF. In the SSF, hexose sugars such as glucose and mannose were consumed faster than xylose, but, in the end of the fermentation >90% of the xylose had been consumed. Chemical analysis of inhibitory pretreatment by-products indicated that the concentrations of heteroaromatic aldehydes (such as furfural), aromatic aldehydes, and an aromatic ketone decreased as a consequence of the aeration. This was attributed mainly to evaporation caused by the gas flow. The results indicate that further research is needed to fully exploit the advantages of LPMO without compromising fermentation conditions.