Umeå University's logo

Limestone is calcined into quicklime in lime kilns at temperatures above 1000°C. Heat is supplied through combustion inside the kilns, which are insulated with a lining of refractory bricks to mitigate heat loss and to protect the kiln from the hot, chemically aggressive, and mechanically abrasive environment. While magnesia bricks have proven to be effective lining materials, they are still susceptible to extensive wear in lime kilns, especially in the burn zone. Refractory corrosion, in particular, can occur when melted fuel ash infiltrates the refractory materials through pores and small cracks. This resultant wear can lead to high maintenance and operational costs, often due to unplanned kiln shutdowns.

To reduce the release of fossil-based carbon dioxide into the atmosphere from lime production kilns, there is a growing interest in introducing bio-based fuels with only relatively minor modifications to the process. Biomass fuels can be sourced from bio-based waste streams from industries or be specifically cultivated for combustion. However, the ash content and properties of bio-based fuels tend to be problematic from an ash chemistry perspective. Therefore, before introducing a new fuel source, it is essential to investigate its potential effects on the kiln lining material. 

In this thesis work, the interactions between melted olive pomace ash and coal ash with commercially available magnesia refractory materials, primarily composed of periclase (MgO) with minor amounts of spinel (MgAl₂O₄), were studied. A procedure for quantifying the intrusion depths was described. Refractory samples were exposed to the fuel ashes under a simulated lime kiln atmosphere with high CO₂ levels at 1200 and 1400°C for 15 and 60 minutes. Cold crushing strength tests were conducted on refractory samples exposed to coal and olive pomace ash, along with CaO powder, at 1400°C for 96 hours. Additionally, postmortem analyses of spent MgO-based refractory bricks were carried out to investigate their chemical characterization and resistance to slag attack after serving as part of the lining in a quick lime rotary kiln for six months.

The morphology and elemental compositions of the exposed samples were examined using scanning electron microscopy and energy-dispersive X-ray spectroscopy. Crystalline phases were investigated with powder X-ray diffraction. Thermodynamic equilibrium calculations were performed to further investigate the ash’s melting behavior in contact with the refractories.

The results indicated that the potassium-rich olive pomace ash exhibited a greater tendency to infiltrate compared to the silicon-rich coal ash, while the latter formed a glassy melt layer on top of the refractory samples. The ash slags primarily infiltrated through the porous matrix and grain boundaries of the refractory materials. Also, refractory phases were observed in both types of ashes, indicating migration of refractory constituents. K₂MgSiO₄ phase was found in the olive pomace ash residues on top of the samples, both for the 1200°C and 1400°C exposures. Similarly, Al₆Si₂O₁₃ phase was dominant in the residual coal ash, in both the 1200°C and 1400°C exposed samples. None of these phases were present in the original ashes.

The results of the postmortem analysis revealed that there was no potassium (K) from the fuel ash present on the hot side of the refractory bricks. However, some K was detected in the middle and back parts of the bricks. On the other hand, some phases, possibly connected to degradation, could be found on the hot side of the bricks, where most of the wear was observed.

The crushing strengths increased after exposure for all samples, except for those exposed exclusively to coal ash. One possible explanation for this is that the refractory materials exhibited a sintered structure, as a result of their interaction with the ashes and CaO. However, in the samples exposed to coal ash, forsterite (Mg₂SiO₄) was identified, which can be considered a corrosion product.